Bull Cedoc Bull Escala 2104 TS4, Руководство по установке

Страница: 47 / 87

Connecting the 2104 Model TS4 to the host system
Perform the following steps to connect the 2104 Model TS4 to the host system:
1. Refer to your preinstallation planning information or 2104 Model TS4
configuration information and check how the 2104 Model TS4 is to be
connected to the host system. Verify your configuration by referring to “Valid
configurations” on page 25.
2. Attach identification labels to the external SCSI signal cables (see the
appropriate Adapters, Devices and Cables Information manual for details). See
Figure 30.
3. Tighten the retaining screws. Plug the SCSI signal cables into the connectors
1
on the SCSI interface cards. Ensure that the retaining screws on the
connectors are tightened. If necessary, use a small screwdriver to do this.
Attention: Do not use a power-driven screwdriver during this step; it could
produce excessive torque and break the screw or card.
4. Ensure that all SCSI signal cables are correctly connected. An incorrect
connection can prevent the 2104 Model TS4 from powering on fully.
SC000263
Figure 30. Connecting SCSI cables
Installing and testing the 2104 Model TS4
19