Buick 2005 LaCrosse, Руководство пользователя

Страница: 109 / 410

Read the instructions completely before attempting to
program HomeLink
®
. Because of the steps involved, it
may be helpful to have another person available to
assist you in the programming steps.
Keep the original hand-held transmitter for use in other
vehicles as well as for future HomeLink
®
programming.
It is also recommended that upon the sale of the
vehicle, the programmed HomeLink
®
buttons should be
erased for security purposes. See “Erasing HomeLink
®
Buttons” later in this section or, for assistance,
contact HomeLink
®
on the Internet at:
www.homelink.com or by calling 1-800-355-3515.
Be sure that people and objects are clear of the garage
door or gate operator you are programming. When
programming a garage door, it is advised to park outside
of the garage.
It is recommended that a new battery be installed in
your hand-held transmitter for quicker and more
accurate transmission of the radio-frequency signal.
Programming HomeLink
®
Your vehicle’s engine should be turned off while
programming HomeLink
®
. Follow these steps to program
up to three channels:
1. Press and hold down the two outside HomeLink
®
buttons, releasing only when the HomeLink
®
indicator light begins to flash, after 20 seconds. Do
not hold down the buttons for longer than
30 seconds and do not repeat this step to program
a second and/or third hand-held transmitter to
the remaining two HomeLink
®
buttons.
2. Position the end of your hand-held transmitter
about 1 to 3 inches (3 to 8 cm) away from the
HomeLink
®
buttons while keeping the indicator light
in view.
3. Simultaneously press and hold both the desired
HomeLink
®
button and the hand-held transmitter
button. Do not release the buttons until Step 4 has
been completed.
Some entry gates and garage door openers may
require you to substitute Step 3 with the procedure
noted in “Gate Operator and Canadian
Programming” later in this section.
2-37