7
Audio System
Controls:
PWR (Power)
VOL (Volume)
DISP (Display): Press this button to
switch the display between the radio
station frequency and the time.
SCV (Speed-Compensated Volume):
SCV adjusts the audio system volume
automatically to make up for road and
wind noise as you drive. To access the
SCV display, press the TUNE/AUDIO
button repeatedly until SPEED VOL
appears. Then select from OFF, MIN,
Tire Inflation Monitor
(if equipped)
A LOW TIRE light will come on if the air
pressure in one tire becomes approxi-
mately 12 psi lower than the car’s nor-
mal tire pressure. After filling a low tire
with air, or after changing or rotating
your tires, the Tire Inflation Monitor must
be reset. The red reset button is located
inside the fuse box, found near the end
of the instrument panel on the passen-
ger side. To reset the monitor, turn the
ignition switch to RUN; then press and
hold the reset button for at least five
seconds.
See Section 5 of your Owner Manual.
MED or MAX. Each higher choice allows
for more volume compensation at faster
vehicle speeds.
BAND: Press this button to switch
between AM, FM1 and FM2.
TUNE: Turn this knob to choose a radio
station.
: Press the right or left arrow to
go to the next or to the previous station
and stay there. To scan stations, press
and hold one of the SEEK arrows for
two seconds until SCAN appears on the
display. Press one of the SEEK arrows
to stop scanning.
Numbered Buttons
The six numbered pushbuttons let you
return to your favorite preset stations.
(See your Owner Manual for setting your
favorite stations.)
AUDIO: Allows you to adjust the Bass,
Treble, Balance and Fade.
EQ: (Equalizer)
Using the RDS
The Radio Data System (RDS) uses the
FM band to seek stations broadcasting
the selected type of programming,
receive local or national emergency
announcements, display radio station
messages or seek stations with traffic
announcements. This system only works
when information is available from the
stations.
When using RDS, the station name, call
letters or program type (PTY) informa-
tion will appear in the display instead of
the frequency. The RDS system includes
these controls:
P-TYP (Program type): Press this button
to find and select a desired program
type.
