Buhler Allied FK314, Руководство оператора и каталог запасных частей

Страница: 7 / 23

85” Snowblower
- 5 -
OPERATING INSTRUCTIONS
1. Adjust the top link of the tractor hitch so that the snowblower is level when
resting on the ground.
2.
Adjust the lower link sway chains or blocks on the tractor to restrict side
movement of the blower when operating.
3. Run the blower at low RPM to check operation.
4. The snowblower has two shear bolts to protect the tractor and blower in
case a large object enters the blower. PTO shear bolt – two 5/16" x 1"
(grade 5), auger shear bolt - 5/16" x 1 ¼” (grade 5). These bolts must be
checked every five operating hours and kept tight to prevent wear of the
bolts and bolt holes.
5.
Daily check the auger bearing bolts on each side of the snowblower, the
drive sprocket bearings and the bolt holding the blower fan on the gearbox
shaft.
6. Grease the PTO and bearings every 40 hours of operation.
7. A little engine oil applied to the chain daily can double the life of the drive
chain.
8. Occasionally apply a light winter grade oil to the chute bottom ring to ease
turning.
9. Always disengage the PTO before dismounting from the tractor.
10. CAUTION: Always check to see that both ends of the PTO shaft
are securely attached as per instructions every time you are preparing to
use the snowblower.
11. Shear sprocket: The shear sprocket (#6) should be checked at the
beginning of every season to make sure it will spin freely. With time this
sprocket could corrode and seize which will not allow the shear bolt to
break if something jams in the snowblower auger. Clean to loosen if
necessary.
12. Gearbox: Use any 80-90 gear oil or multigrade with 80 minimum.
13. When replacing bearings or tightening a loose bearing collar, always
tighten collar in the direction of shaft rotation using a center punch or
similar tool.