Bugera VEYRON BV1001M, Быстрый старт

Страница: 7 / 12

13 Quick Start Guide 12 BUGERA VEYRON BV1001T/BV1001M
(EN)
Step 2: Controls
(1)
INPUT Connect your bass using a ¼"
unbalanced cable.
(2)
MUTE button mutes the output of the
amplifier for silent tuning or for switching
bass guitars. The LED ring around the
button will light to indicate clipping at the
input jack.
(3)
-15 dB button reduces the sensitivity of
the input jack for use with active pickups.
The LED ring around the button will light
when the reduction is engaged.
(4)
GAIN knob adjusts the amount of
preamp level.
(5)
VOLUME
knob (BV1001T only) compensates
for boosts in the signal from the GAIN knob.
It also affects the level of the FX LOOP
SEND jack.
(6)
COMP button engages the compression
effect. The LED ring around the button will
light during the peaks in your playing to
indicate that the signal is being compressed.
(7)
COMP knob adjusts the amount of
compression of the built-in compressor.
(8)
BASS knob adjusts the low frequencies of
the tone.
(9)
MID knob adjusts the mid frequencies.
(10)
MID FREQ knob selects the center frequency
that is adjusted by the MID knob.
(11)
TREBLE knob adjusts the high frequencies
of the tone.
(12)
MASTER knob adjusts the overall output of
the amplifier.
(13)
ULTRA LOW button (BV1001M only) adds a
fixed low bass boost to the tone.
(14)
ULTRA HIGH button (BV1001M only) adds
an extra high frequency boost to the tone.
(15)
PHONES jack allows connection of
headphones via ¼" stereo cable, e.g. when
the amp is used for practicing without
speakers connected.
(16)
FX LOOP jacks allow connection of effects
processors after the preamp, but before
the power section. The SEND jack can
also be used to pass the preamp signal to
another amplifier.
(17)
AUX IN jack allows connection of MP3
players via ¼" stereo cable for jamming
along to tracks.
(18)
SPEAKER OUTPUT jacks connect to bass
cabinets via professional locking connectors.
(19)
TUNER OUT jack sends the signal to an
external tuner. This output remains active
when the MUTE is engaged.
(20)
FOOTSW(itch) jack accepts the footswitch
for MUTE and FX LOOP on/off .
(21)
DIRECT OUTPUT jack sends the preamp
signal via XLR cables for connection to a
mixer or interface. The 3 switches allow
ground lift, pre or post EQ, and mic or
line level.
BUGERA VEYRON BV1001T/BV1001M Controls
(1) (2) (3) (4) (5) (6) (7) (8) (9) (10) (11) (12)
(12) (1) (2) (3) (4) (6) (7) (13) (8) (9) (10)
(15)
(18) (19) (20) (21)
(16) (17)
(11) (14)