Buffalo Sportsman GEN10K, Инструкция по эксплуатации

Страница: 21 / 32

GEN10K 10,000 Surge Watts/7,000 Running Watts Portable Generator 21
STORAGE/TRANSPORT PROCEDURES
Never place any type of storage cover on this generator while it is still hot.
When transporting or storing this generator for extended time:
• Allow generator to fully cool before moving it. A hot engine and exhaust system can burn you and ignite some materials.
• Empty the fuel tank. (See “Emptying the Fuel Tank” in the “Maintenance/Care” section.)
• Turn the fuel valve to the “off” position.
• Disconnect the spark plug.
• Do not obstruct any ventilation openings.
• Do not drop or strike this generator while moving it.
• Store this generator in a cool dry area, free of excessive dust.
Storage Time Recommended Storage Procedure (which will help prevent difficult starts)
Less than 1 month No storage procedure required.
1 to 2 months Fill with fresh gasoline and add gasoline conditioner
2 months to 1 year Empty the fuel tank. (See “Emptying the Fuel Tank” in the “Maintenance/Care” section.)
1 year or more Empty the fuel tank. (See “Emptying the Fuel Tank” in the “Maintenance/Care” section.)
Disconnect the spark plug.
TROUBLESHOOTING
IMPORTANT: If trouble persists, call our customer help line at
1-866-460-9436
, Monday - Friday, 8 AM - 4 PM Central Time.
Symptom Cause Solution
Engine switch is set to "off." Set engine switch to "on."
Fuel valve is turned to "closed." Turn fuel valve to "open."
Choke is open. Close the choke.
Engine is out of gasoline. Add gasoline.
Engine is filled with contaminated and/or old
gasoline.
Drain gasoline from the engine and add new
gasoline.
Spark plug is dirty. Clean spark plug.
Spark plug is broken. Replace spark plug.
Generator is not on level surface. Move generator to a level surface to prevent
triggering the low oil shutdown.
Engine will not start.
Oil is low. Add or replace oil.
Circuit breaker is off. Flip circuit breaker to "on."
Reset button is "off." Push reset button to "on."
Bad connecting wires/cables. Try a different extension cord.
Engine runs but there is no electrical output.
Bad electrical device connected to generator. Disconnect device, try connecting another
device.
Generator is overloaded. Reduce draw on generator to within this
generator's rated wattage by reducing number
of connected electrical devices.
Short in one of the connected devices. Disconnect any faulty or short-circuited
electrical loads.
Generator runs but does not support all
connected electrical devices.
Air filter is dirty. Clean or replace air filter.
BATTERY TRAY INSTALLATION
A battery must be installed before the electric start feature can be used. Disconnect all electrical loads from this generator before changing the
battery. The battery case is located behind the metal plate under the control panel. Install the battery by using the two cables (one red and the other
black) that are attached to the engine. Attach the red/positive cable to the positive terminal on the battery. Attach the black /negative cable to the
negative terminal on the battery. Slide the attached battery into the battery case.