PS07414 Electric Jig Saw Assembly & Operating Instructions
5
TOOL USE
The Electric Jig Saw is capable of
cutting hardwood, softwood, plywood, plastic, mild steel plate, aluminum
plate, copper plate, synthetic resins such as phenol resin, and thin and soft construction materials.
BLADE INSTALLATION
Before installing or replacing the saw blade, make sure the power cord is unplugged.
Failure to do
so could result in serious injury or electric shock.
Always use the proper blade for this saw.
Blades that do not properly fit will cause loss of control.
Before cutting, double check the tightness of the blade.
Serious injury could occur if the saw blade is
not securely in place.
1. Loosen the Hex Bolt (A) by using the hex wrench.
2. With the blade teeth facing forward, insert the
blade into the side of the blade holder (B) with the
dot (the opposite side of the hex bolt).
3. The notch at the end of the blade should rest on
the roll pin.
4. Tighten the hex bolt with the hex wrench.
5. Make sure the back edge of the blade fits into the
Roller (C). To adjust the position of the Roller,
loosen the base adjustment Bolt (D) on the
underside of the saw. Tighten Bolt before
plugging in the saw.
SAW OPERATION
Wear safety eyewear and dust filters or respirators while using this tool.
Always keep both hands on the handles. This will ensure they are safe from the cutting path
of the blade.
Before beginning, make sure there is plenty of space below the work piece for the saw blade to pass freely.
Hold the saw firmly, with one hand on the front grip and the other on the top handle. Be sure the power cord
and any extension cords are out of the cutting path. If both hands are on the saw, they are free from the path
Hex Bolt (A)
Roller (C)
Blade is Inserted Here (B)
Bolt (D)
