Buffalo Tools PC3000, Инструкция по эксплуатации

Страница: 9 / 23

ITEM # PC3000 Plate Compactor Instruction Manual
9
STOPPING THE UNIT
To stop this unit:
1. Set the engine power switch to the “OFF” position.
Allow this unit to cool down before touching areas that become hot during operation.
Allowing gasoline to sit in this unit's fuel tank for extended time without use can increase the difficulty in starting this unit in the future.
Never store this unit for extended time with gasoline in the fuel tank.
MAINTENANCE/CARE
Proper routine maintenance of this unit is essential for safe, economical, and trouble-free operation. It will help prolong the life of this unit as well as
help reduce air pollution. Perform maintenance checks and procedures according to the schedule in Figure 7.
Never perform maintenance procedures while this unit is running. Allow this unit to cool before commencing any maintenance
procedures. Keep heat, sparks and flame away.
Improper maintenance and/or failure to correct any problems prior to operating this unit can cause a malfunction which could cause death
or serious injury. Always follow the inspection and maintenance recommendations and schedules in this manual.
Recommended Maintenance Schedule
Each Use Every Month or
Each 20 Hrs Every 3 Months or
Each 50 Hrs Every 6 Months or
Each 100 Hrs Every Year or
Each 300 Hrs
Engine Oil Check Level X
Replace X (first use) X
Air Filter Check X
Clean X
Spark Plug Check/Clean X
Fuel Tank Verify Gas Level X
Clean X
Figure 7 - Recommended maintenance schedule
Cleaning the Unit
Always try to use this unit in a cool dry place. If this unit becomes dirty, the exterior can be cleaned with a damp cloth, soft brush, vacuum and/or
pressurized air. Never clean this unit with a bucket of water and/or a hose as water can get inside and cause a short circuit or corrosion. Never use
gasoline to clean parts of this unit.
Replacing The V-Belt
1. Loose 4 engine mount bolts (do not remove) only enough to move the engine forward.
2. Loosen the jam nuts B and bolts A shown in above figure.
3. Slide the engine toward the front of plate and slip the old V-belt(s) off of the wheel pulley and install the new V-belt(s) in
their place.
4. Position the V-belt(s) over the engine pulley.
5. Move the engine back.
6. When the V-belt tension is correct, tighten the jam nuts B and the engine mount bolts.
7. Replace the belt guard