Buffalo Tools 800449, Инструкции по сборке и эксплуатации

Страница: 11 / 16

4.5 Inch Metal Cutting Bandsaw Assembly & Operating Instructions 11
Vertical Cutting
Fitting the table:
Loosen the A & B Screws from the blade guide. Take away plate D.
Locking the saw in vertical position:
Rotate the bracket to an upright position, locate in notch on saw arm and tighten. If you have difficulty
positioning the bracket in the notch, adjust nearby screw at bottom of saw until bracket is positioned,
then tighten bracket.
MAINTENANCE
Lubricate the parts listed below using SAE30.
1. Ball Bearing – none required
2. Blade guide bearing – none required
3. Driven wheel bearing – none required
4. Vice lead screw – as needed
5. Drive gears run in the oil bath and won’t require lubricant change more than once a year. When
changing, put down the head to a horizontal position and loosen screws on the gearbox. Open the
cover and place pan under the right lower corner of the gear box. Slowly raise the head until the oil
flows out. Lower the head and wipe up excess oil. Add lubricant until it is full. Close cover and tighten
screws.