Buell XB 2008 Series, Руководство по обслуживанию

Страница: 305 / 688

3.12 OIL COOLER
GENERAL
For engine oil flow through the engine, See 3.8 OILING
SYSTEM .
Engine oil flows from the oil pump to the oil cooler through a
supply hose. The oil circulates through the finned tubes of the
cooler to dissipate heat and returns to the oil pump through a
return hose.
1
2
3
4
6
8
7
5
sm04225
1. Oil cooler feed line
2. Oil cooler return line
3. Oil cooler
4. Screws with washers
5. Stabilizer bracket
6. Screw with washer
7. Oil cooler scoop
8. Screws with washers
Figure 3-100. Oil Cooler: XB Models
REMOVAL
1. Cover the front chin fairing to protect finish.
NOTE
Dispose of oil in accordance with local regulations.
2. Place a container under the motorcycle to catch excess
oil.
3. Disconnect oil cooler return line (2) at oil cooler.
4. Disconnect oil cooler feed line (1) at oil cooler.
5. Remove two fasteners (8) securing the oil cooler scoop
(7) and remove scoop.
NOTE
Place protective covering over primary cover to prevent cos-
metic damage when removing and installing fastener for stabil-
izer bracket.
6. Remove fastener (6) securing oil cooler to stabilizer
bracket (5).
7. Remove the fasteners (4) holding the oil cooler (3) to
mounting bracket.
8. Remove oil cooler from bracket.
NOTE
Check the oil cooler for dirt and debris.
INSTALLATION
1. Slide the oil cooler back onto the bracket.
2. After the oil cooler (3) is in place, apply LOCTITE 271 (red)
to the two fasteners (4) and tighten to 96-108 in-lbs (10.8-
12.2 Nm).
3. Install the stabilizer bracket fastener (6) and tighten to
66-78 in-lbs (7.5-8.8 Nm).
4. Install oil cooler scoop (7) and apply LOCTITE 271 (red)
to the two fasteners (8) and tighten to 48-72 in-lbs (5.4-
8.0 Nm).
5. Connect feed oil line (1) to oil cooler.
6. Connect return oil line (2) to oil cooler.
2008 XB Service: Engine 3-69