Boiler block assembly
8
Logano GE515 - We reserve the right to make any changes due to technical modifications.
19
8.1
Arrangement of boiler sections within
the boiler block
The boiler block is assembled from the rear to the front,
commencing with the rear section (Fig. 8,
[3]
,
page 18).
Always assemble the front section (Fig. 8,
[9]
last.
During assembly please observe the arrows denoting
the direction of installation (Fig. 8,
[8]
) and proceed
according to the following instructions and illustrations.
8.2
Joining the boiler block assembly
Prior to fitting the front and rear sections, remove the
nuts and washers from the bolts on the boiler section
hubs.
z
Remove the clean-out covers on the rear section
(Fig. 10,
and
[2]
).
Fig. 9
Rear section with mounted installation template
CAUTION!
DANGER OF INJURY
through inadequately secured boiler
sections.
z
With the installation template, secure
the rear/end section against tipping.
Buderus supplies the installation
template (accessory) on request.
USER NOTE
z
Remove the clean-out cover from the
rear section, if you are using the
installation template, to secure the
template.
Fig. 10 Remove the clean-out covers
2
1
