BUDDY EQUIPMENT EXD1100, Руководство оператора

Страница: 42 / 52

42
Extreme Duty
Buddy
Mortar Mixer
Maintenance
Hardware
Periodically inspect all hardware on the mixer and engine. Loose hardware can contribute to
early component failure and poor performance.
NOTE: Some hardware is used to retain parts that have to move freely for correct operation
of this unit. These items include the guard lifter and drum guard. The hardware for these
items should be snug enough to prevent excessive play, yet loose enough to allow the parts
to pivot freely.
Wheel Bearing Lubrication
Fill wheel hub with grease to inside diameter of outer races and also fill hub grease cap.
Never use grease heavier than 265 A.S.T.M. penetration (No. 2 grade). Grease bearing cone
by machine or by hand method. Force grease between rollers, cone and cage. (If Ball
Bearing Hub: force grease between balls.) It is not recommended that a pressure grease
fitting be installed on the hub.
Wheel Bearing Adjustment
Tighten the adjusting nut with a 12" wrench, at the same time turn the wheel in both
directions, until there is a slight bind to be sure all bearing surfaces are in contact. Then
back off adjusting nut 1/6 to 1/4 turn or to the nearest locking hole to allow the wheel to
rotate freely within limits of 0.001 inch to 0.010 inch end play. Lock nut at this position.
Drum Seals
Grease zerks daily with lithium based grease.
CLEANING
FAILURE TO FOLLOW CLEANING INSTRUCTION AND/OR ROTATION OF DRUM WITHOUT
GUARD LIFTER CONNECTED CAN RESULT IN SERIOUS INJURY.
For consistent performance, long life and continued high quality mixing of plaster or
mortar, thoroughly clean the mixer inside and out at the end of each day's operation. To
prevent lumps of dried plaster from forming and contaminating future batches of plaster or
mortar, do not allow build up of materials to form on drum guards, around paddles or
anywhere inside the drum.
DO NOT beat on the drum with a shovel, hammer or other device to break up accumulations
of dried mix, as this will dent and damage the drum.
 Before cleaning, shut the engine or motor and disconnect the spark plug wire or
electric cord to prevent accidental starting.
 Keep drum guard closed.
 Always keep guard lifter connected.
 Keep drum in upright, mixing position.
 Spray mixer with water before mix dries to remove accumulation.
 Rotate drum to dump position to remove debris.
WARNING