Bucktool DC30A, Инструкция по эксплуатации

Страница: 10 / 16

11
DC30A
ASSEMBL
Y INSTRUCTIONS
WALL MOUNT INSTRUCTIONS
Verify that the plate is securely attached to the wall before mounting the collector unit
1. Mount the plate (1) to the wall
by the ST hex head screw (2)
Set screw (3) . As shown in Fig1.
1. Do not remove the rubber foot from
the unit base.
2. With the aid of an assistant, lift
and position the unit so that the
align with the two studs.
Fig. 2
3. Slip the base key hole slots (A)
over the stud end nuts and allow
See figure 2.
4. Use the end nuts (5) and washers
(6) to secure the base to the
studs. When sufficiently tight,
the rubber foot will touch
During operation, the collector unit should not vibrate excessively. If excessive
vibration occurs, check tightness of all fasteners. Retighten if necessary. If
excessive vibration continues, unit may have to be mounted to a different wall
position, or removed entirely from wall mount operation.
1
2
3
3
4
4
5
6
To hang the unit from the plate:
CAUTION
!
to the plate.
CAUTION
!
Fig. 1
key hole slots on the unit base
the base to rest on the stud
threads.
the wall surface.