15
moved only by one number at a time leaving approx. one
minute between each setting change.
4. BURNER DOES NOT LIGHT EASILY.
Read the instructions in the lighting section of this
publication.
OIL WILL NOT ENTER THE POT.
Is there oil in the fuel tank?
Has the fire valve tripped?
Has the isolation valve been accidentally turned off?
Is the oil turned on at the oil flow control knob on the
valve?
Is the oil feed pipe from the valve to the pot?
Blocked. (Unlikely)
Has the water stat tripped off on the aqua stat?
Has the aqua-stat been damaged by overheating.
To check this out, remove the aqua-stat from the
valve and remove the phial from the boiler, re cock the
valve and test fire the appliance. See Fig 4 Toby Valve
document.
Note this type of damage is not covered by the
warranty.
6. OIL SMELLS
Visual check on all joints for obvious leaks.
Check that the descaling lever packing gland nut is
adjusted.
7. DEFLOODING A FLOODED POT.
To carry out this procedure you will need -:
a. A small leak proof plastic bag.
b. A small sponge.
c. A larger plastic bag for disposal of the residue.
d. A pair of disposable plastic gloves.
If the pot becomes flooded, de flood it is as follows -:
Put a small plastic bag into the stove and sponge from
the pot into the bag, when the excess oil has been
removed put the plastic bag and sponge into another
plastic bag and dispose of it.
8. OPERATING OIL FLOW RATES
OIL Flow rates in cc per minute.
Min
Max
4cc
10cc
Oil Flow Rates In litres Per hour.
.24 litres
.6 litres
Oil Flow Rates In litres Per 24 hours.
5.76 litres
14.4 litres
Oil Flow Rates In litres Per 7 x 24 hours.
40.32 litres 100.8 litres
1
1
0
0
.
.
R
R
O
O
U
U
T
T
I
I
N
N
E
E
S
S
E
E
R
R
V
V
I
I
C
C
E
E
M
M
A
A
I
I
N
N
T
T
E
E
N
N
A
A
N
N
C
C
E
E
.
.
Continuous running assumed.
1. EVERY 4 WEEKS-:
Operate the descaling lever by turning it completely
two or three times.
2. AS REQUIRED -:
Clean inside of door glass.
3. EVERY EIGHT WEEKS -:
Clean the burner completely by removing all the inner
components as follows,
1. Open the front door.
2. Remove the coal kit if it has been supplied with the
stove.
3. Remove the inner mesh catalyser.
4. Remove the lower burning ring.
Scrape the bottom of the pot and remove all carbon
build up.
Reassemble in the reverse order.
4. EVERY 24 WEEKS-:
Tighten up the gland nut on the descaling device to
stop oil smells.
5. ONCE PER YEAR-:
Have your service man replace or clean all the filters
in the oil supply line.
6. EVERY TWO YEARS -:
Have your service man clean the filter in the Oil
Control Valve and check the function of all the safety
equipment associated with the stove, oil supply and
plumbing system.