Bubble 2 Rayburn Regent, Инструкция пользователя, Страница: 8 / 13

Occasionally scrape away any hard carbon deposits from the bottom of the burner pot.
5
5
E
E
X
X
T
T
I
I
N
N
G
G
U
U
I
I
S
S
H
H
I
I
N
N
G
G
Shutting the burner off is a very simple manoeuvre.
Turn the oil flow control knob FULLY in a clockwise direction until you feel it stop in its off
position.
After a few minutes, the flame will die down and eventually extinguish itself.
DO NOT TOUCH THE STOVE UNTIL IT HAS COMPLETELY COOLED DOWN.
NEVER TRY TO RE LIGHT A HOT BURNER, MAKE SURE THAT THE BURNER IS
COMPLETELY COOLED DOWN BEFORE RE LIGHTING.
6
6
F
F
U
U
E
E
L
L
S
S
U
U
P
P
P
P
L
L
Y
Y
I
I
N
N
F
F
O
O
R
R
M
M
A
A
T
T
I
I
O
O
N
N
Your Fuel is stored in an oil tank, which should incorporate the following features.
1. 1 A fuel gauge, which can be in the form of a numbered circular dial or a site glass into
which oil is fed so as to indicate the amount of oil in the tank.
2. 2 A manually operated isolation valve on the tank, usually a gate valve.
3. 3 A fuel filter to filter out any small particles of dirt or contamination, which may get into
the oil or tank.
4. 4 An automatically operated safety valve designed to shut off the oil supply should a fire
occur near to the stove.
5. 5 A manually operated isolation valve near to the stove to allow you or the service man
to turn the oil off should the need arise.
If you allow the stove to run the oil tank dry it will obviously go out.
Before filling the fuel tank you must make sure that the oil valve is tripped to it’s off position,
otherwise the pot will flood.
If the pot floods do not attempt to light the stove until the excess oil has been removed from it.
7
7
T
T
H
H
E
E
C
C
O
O
A
A
L
L
K
K
I
I
T
T
The coals are located on the coal support bars, which are designed to glow red in the flame,
passing on the incandescence into the coals.
Care must be taken when positioning the coals on the spikes.
Do not fit any extra coals, as this will invalidate the product warranty.
The whole system is designed so that it can be removed in its entirety without the need to disturb
the coals making routine cleaning and servicing very easy.
To remove it turn the stove off and when it is cooled down, undo the front door knob, open the
door and carefully lift it out, using the front fret.
The coal support bars and coals may need replacing from time to time and they are available
from your supplier as a service item.
Take care not to drop any coals into the pot.