Part #:
101.8010
Description:
Motor, 24V DC, Panel
Power Rating:
24V DC - 0.6A (15V Battery)
Recommended Supply:
ABC-11-W or ABC-13-W
Max Pulling Force:
6.6 lbs
Chain Speed:
2.5 in/sec
Operating Temperature:
41 - 140° F
Max Channels to Pair:
32 Channels
Physical Weight:
8.2 ounces (0.5 lbs)
www.btxinc.com
Dallas, Texas - USA
2.4 GHz Traversing Motor Programming
(Drapery & Panel)
The Panel and Vertical systems do
not require limit settings due to an
auto-calibration function. Calibrating
the system is the first thing you need
to do before proceeding with other
programming functions.
1. To calibrate, press the “Program”
button on the motor. The system will
run end to end and then stop. The
limits should now be set.
Calibrating the System
Learning a Channel
1. Press the “Program” button on the motor and the system will begin to step back and
forth.
2. Select the desired channel on the handsender and press the “Program” button on
the back of the remote. You likely need a pen or paper clip.
3. Continue to other program functions or exit program mode by pressing the “Program”
button on the motor. Once exited, the motor will stop stepping.
In order to program the motor, the system must first be connected to a power source.
Note:
2.4 GHz motors are initally programmed via a programming button located at
the head of the motor. Alternatively, you may enter programming mode via the
Single
Select
feature, however, this only works if the intended motor is already learned to the
handsender or the motor has not been learned to any handsender (factory default).
Note:
It is possible to program multiple motors simultaneously by placing all intended
motors in program mode, then learning the handsender and channel.
