4
U
se
r
M
a
n
u
a
l
Installation and operation
Please refer to figure above and setup guide below:
10- Remove the cap cover from the top of the lens mount.
11- Screw the lens into the lens mount.
12- Connect the video output (10) to the monitor or other video device through a 75 Ohms type coaxial cable.
13- Connect the power source (7), AC with the power cord, or DC by using the DC Jack (+12V DC is in the center of the jack
plug), then the LED indicator (3) will lit.
14- Once the picture appears on the monitor, adjust the focus and iris of the lens to obtain the best picture.
15- When the subject is not in focus after adjusting the focus of the lens, adjust the back focus as follows:
4FUUIFMFOTGPDVTSJOHUPJOGJOJUZ ž
Take picture of the subject at a distance more than 20M away.
Loosen the screw securing the lens mount (use L-wrench).
Turn the lens and secure it to the lens mount so that the subject is in focus and the picture is clear.
Tighten the screw securing the lens mount (2).
16- Mount the mounting bracket to hole (1) on the top or bottom of the camera, using the enclosed 8mm mounting block
with 2 screws furnished.
17- Auto Iris Function
When using an auto iris lens, SW1 (9) should be in the “AI/ MI” position to disable AES function. Before plugging
the enclosed miniature 4 pins to the auto iris connector (4), please check the type of auto iris lens used, and also
the compatibility on the polarities.
When using DC Drive auto iris lens is used (or Direct Drive), the switch (5) should be in the “DC Drive” position.
Adjust VR (6) to the proper level.
When Video Drive auto iris lens is used, the switch (5) should be in the “Video DR” position.
When using manual iris lens, the switch SW1 (9) is select-able depending on the application environment.
18- When using the BLC (Back Light Compensation) function, the switch SW2 (8) should be in position with “BLC”.
Specifications
Specifications
391697
391699
Sensor
1/3" Color Hi-Res
Horizontal resolution
PAL :
540 TVL
Scanning
Interlaced
Day/Night
Yes
Minimum illumination
ICR (IR Cut Filter)
No
Infrared (IR) light distance
-
Infrared (IR) light angle
-
OSD (On Screen Display)
No
WDR (Wide Dynamic Range)
No
Masking
No
Lens / Lens mount
CS
IP degree of protection
-
Power supply voltage
12 VDC (+ -)10%
110 – 230 V~
Power consumption
12 V =
100 mA ,
230 V~
5 mA (1 W)
Operating temperature
De -10 °C à 50 °C
Product dimensions
115 mm x 50,20 mm x 42,20 mm
Product weight
215 g
235 g
Содержание 391697
Страница 1: ...IT 391697 391699 LE03726AB 01CB 12W40 Manuale Di Istruziono User Manuall...
Страница 3: ...EN 3...