BTEK HRB, Руководство по установке

Страница: 12 / 20

HRB Bench Scale Installation Instructions 13
4.1 Draft shield option
4 Option installation
4.1 Draft shield option
These instructions cover the installation of the HRB draft shield kit, AWT05-508040.
The kit consists of the parts shown below. A 5/32” hex wrench is also included.
1. Start by removing the four corner screws with a 5/32” Allen wrench. Use the
same screws to attach the pillars. The top of the corner posts will be curved
outward. This bow has been designed into the posts to provide tension on the
sliding panels as they operate.
2. Peel the protective paper off the side panels and attach a knob to each panel
with the screw and plastic spacer as shown below.
Side
plates
Side
plates
Top
plate
Hardware
Corner
posts
Knobs
Knob screws with
nylon spacers
Top plate
screws
Hardware closeup