BT TM-7, Руководство пользователя

Страница: 5 / 24

B T P A I N T B A L L . C O M
4
Eye Function
The TM-7 board is pre-programmed to activate the eye system each time
the marker is powered up. See Section 7 (Break beam Eyes Operation) for
more details.
Installing a Loader and Paintballs
The TM-7 comes equipped to accept 1.03" (outer dimension) standard-
gravity feed loaders as well as most agitating and force-feed loaders. Fit
the loader directly into the feed elbow. It might be necessary to adjust the
feed elbow pinch bolt to your loader.
The TM-7 uses .68 Caliber, water-soluble paintballs, readily available at
paintball pro-shops, commercial playing fields, and many sporting goods
stores. The paintballs are feed from the loader through the feed elbow
and into the breech of the marker.
Notes:
•
The shell of TM-7 is designed so you
can install the Empire Magna
transmitter kit.
Stock Adjustment
The TM-7 Stock can be adjusted by pushing the stock adjustment lever to
the left. Adjust the stocks length by pulling or pushing on the back of the
stock. Make sure the lever springs back to the right to lock it in position.
Foregrip Adjustment
The TM-7 foregrip can be adjusted in two
ways.
• To slide the foregrip, remove the foregrip
retention screw and then slide it to the
desired position and then reinstall and
tighten the retention screw.
• To tilt the foregrip back simply press the tilt button located on the left
side of the foregrip.
6. Firing the TM-7
Keep your finger out of the trigger guard and away from the trigger, point
the barrel of your marker in a safe direction at all times during this
process. Be sure your goggles are securely in place and make sure the
TM-7 marker is OFF. Push the Power button and hold for 2 seconds until
the LED light changes from Green to Red
Warning: Always keep your TM-7 pointed in a safe direction! Everyone
within firing range should always use paintball approved eye and face
protection in the presence of live paintball markers.
• Place the empty loader onto the marker.
• Be sure that it is securely mounted in place.
• Apply the compressed gas, pressurizing the marker.
• Put the paintballs into the loader.
• Remove the barrel plug, sock or barrel-blocking device.
• Aim the TM-7 in a safe direction.
• Turn the TM-7 ON.
• Move the selector switch to the desired firing mode.
• Aim the TM-7 at the target.
• Place your finger on the trigger.
• Pull the trigger with a smooth squeezing motion.
7. Break beam Eyes Operation
The TM-7 uses a break beam eye system to determine the absence or
presence of a ball for the purposes of reduced paint breakage and opti-
mum rates of fire. The TM-7 board is pre-programmed to activate the eye
system each time the marker is powered up.