4. INPUT ( XLR SOCKET )
Connect the output of the input peripherical ( master or booth outputs of your mixer, outputs of a cd player, a minidisc or sound card of a
computer )
Note : don’t use the three inputs in the same time. Use only one.
5. INPUT ( JACK SOCKET )
Connect the output of the input peripherical ( master or booth outputs of your mixer, outputs of a cd player, a minidisc or sound card of a
computer )
Note : don’t use the three inputs in the same time. Use only one.
6. MID BOOST SELECTOR
Two selections are available for the Mid-Boost, “In” and “Out.” The Out setting produces a flat frequency response curve, while the In
setting gives an added boost in the mid-range frequencies.
7. SPEAKER OUTPUT ( BASS )
connect this output to the input of another speaker ( activ or passive ). This output is for the low frequency ( BASS ) of the signal on the
input.
8. POWER
CONNECTOR
Connect on this socket the AC cable provided with the set
9. POWER
SWITCH
Press this switch to turn the power on, press again to turn the power off. When operating this switch, make sure that all controls are set at
minimum position.
10. LEVEL CONTROL
This button is used to adjust the level of the volume of the speaker
11. INPUT ( CINCH SOCKET )
Connect the output of the input peripherical ( master or booth outputs of your mixer, outputs of a cd player, a minidisc or sound card of a
computer )
Note : don’t use the three inputs in the same time. Use only one.
12. ACCOUSTIC SPACE
The Acoustic Space switch is a 3-position switch used to select the "Acoustic Space" in which the speaker is placed—Half Space
(speakers against wall, 0dB position), Three-Quarter Space (speakers in corners or close to wall, -2dB position), or Full Space (speakers
away from wall, -4dB position).
13. HIGH FREQ
Three settings are possible, -2dB, 0dB, and +2dB. 0dB is a “flat” setting with no attenuation, while the -2dB and +2dB settings will
attenuate or boost the high frequencies (3kHz shelf) by -2dB and +2dB respectively.
14. LOW CUT
This 3-position switch sets the bass rolloff frequency.The lowest setting, 56Hz, is essentially a low cutoff bypass as it does not attenuate
the STUDIO M-5’s frequency response. Other settings are 80Hz and 100Hz.
15. SPEAKER OUTPUT ( TREBLE )
connect this output to the input of another speaker ( activ or passive ). This output is for the high frequency ( TREBLE ) of the signal on the
input.
6
