Motor-driven blocking device EasyLock
8360.0
Installation instruction
Page 6
Version
8360Err_en.doc
2.2 Assembly of the counterpart
The counterpart is assembled in the door leaf. It needs to be assembled in a way that the locking
bolt can extend to the limit stop without contact. The maximum distance between the flange and
the counterpart amounts to 5 mm. This way, it is guaranteed that the locking bolt will move far
enough into the counterpart.
Assembly steps:
1. After having installed the blocking device, connect it to the test device (for the connection
plan, please refer to chapter 3.1). After feeding (e.g. using an accumulator) the blocking
device will open automatically.
2. Glue the assembly aid (adhesive felt) on the locking bolt of the blocking device and color it
using an ink pad.
3. Close the door.
4. Lock the blocking device using the test device. The locking bolt will extend. After several
locking trials the locking bolt will move back since it cannot reach the end position.
5. Open the locking device by using the test device.
6. Open the door.
7. On the door leaf you can recognize a color circle which shows the exact position of the
counterpart.
8. Mark the center using a center punch and drill the hole according to the counterpart. For
the installation dimensions of the counterparts, please refer to the technical data sheet
(also see chapter 6).
9. Assemble the counterpart.
10. Close the door and perform a functional check using the test device (also refer to
chapter 3.3).
Attention: When installing the blocking device on an emergency fire door, please check which
structural measures are allowed so that the door will not lose its certification!
2.3 Emergency opening
Electrical emergency opening:
Guide the leads of the distribution voltage to a place which is accessible in case of a failure (e.g.
behind the bell or the cover of the communicator, or others) in order to be able to use the electrical
emergency opening options. By shortly interrupting and feeding the distribution voltage the bolt will
be moved in – also if the entrance is set to “Closed“. Only after switching over the entry from
“Opened“ to “Closed“ the bolt will be extended again.
