BSL Twist Beam 2R, Руководство пользователя

Страница: 10 / 14

10
5. DMX connection and DMX protocol
5.1 DMX addressing:
5.1.1 The device is controlled by universal DMX 512 protocol, DMX address is the start channel used to receive
instructions from the external controller. For independent control, each fixture must be assigned its unique address
control channels. For example, this device has four channel modes: 13/16/10/12, if we set the mode at standard 13
channels mode, and there are several models need to be independently controlled, we just simply address first fixture
at 1, and second fixture at 14, third one at 27, etc.
If the devices have the same address, they will behave synchronically.
DMX addressing is limited, don’t set the address so high that without enough control channels for the fixtures.
Display is flashing when no DMX signal is received.
5.1.2 This device is equipped with 3-pins DMX in and out sockets only.
Pin 1 = GND
Pin 2 = Signal (-)
Pin 3 = Signal (+)
5.1.3 The termination is prepared by soldering a 120Ω resistor between pins 2 and 3.
5.1.4 Connection: us DMX cable with 3-pin XLR-plugs to connect the controller with the fixture or one fixture with
another.