8
The operator has to make sure that safety-relating and machine-technical
installations are approved by a skilled person once a year.
The projector should be installed outside areas where persons may walk by or be
seated.
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE,
including (but not limited to) calculating working load limits, installation material being
used, and periodic safety inspection of all installation material and the fixture. If you
lack these qualifications, do not attempt the installation yourself, but instead use a
professional structural rigger. Improper installation can result in bodily injury or
damage to property.
The fixture has to be installed out of the reach of people.
If the fixture shall be lowered from the ceiling or high joists, professional trussing
systems have to be used. The fixture must never be fixed swinging freely in the
room.
Caution
: Fixtures may cause severe injuries when crashing down! If you have
doubts concerning the safety of a possible installation, do not install the moving
head!
Before rigging make sure that the installation area can hold a minimum point load of
10 times the fixture’s weight.
The fixture can be placed directly on the stage floor or rigged in any orientation on a
truss without altering its operation characteristics.
For securing a fixture to the truss, install a safety wire that can hold at least 10 times
the weight of the fixture. Use only the safety wire with screw-on carabine. Pull the
safety wire through the safety attachment point on the bottom of the base and around
the truss as shown on the pictures below.
Truss installation
1.Bolt each clamp (1) to the omega holder (3) with M12 bolt and lock nut through the
hole in the holder.
2.Fasten the omega holders on the bottom of the base by inserting both quick-lock
fasteners (4) into the holes of the base and tighten fully clockwise.
3.Pull the safety wire (2) through the attachment point and around the truss (6).
Danger of fire!
When installing the device, make sure there is no highly inflammable
material (decoration articles, etc.) in a distance of min. 0.5 m.
CAUTION!
Use 2 appropriate clamps to rig the fixture on the truss. Follow the
instructions mentioned at the bottom of the base. Make sure that the
device is fixed properly! Ensure that the structure (truss) to which you
are attaching the fixtures is secure.
