Bryston BCD-1, Руководство пользователя

Страница: 6 / 8

4) Upon execution the 1st dialog box at the right will be displayed. Click on OK and the program will search for the BCD-
1’s serial port via any available serial port on your computer.
5) When the BCD-1’s serial port has been found, the dialog box will indicate this by displaying the message “BDC1 found
on ComX”. Click on UPDATE to initiate the update procedure.
6) When completed and the final dialog box is displayed, click on EXIT to finish.
N.B. In some cases it may be necessary to obtain a newer version of the Visual Basic control MSCOMM32.OCX. Contact
Microsoft if you see warnings or cautions concerning this control.
16:
IEC Power Inlet
. Use only approved IEC-320 power cords with C13 type connectors to mate with the BCD-1’s IEC-320-C14
power inlet.
IR REMOTE CONTROL
CODE button :
Programming the BCD-1
:
Turning the Display ON or OFF: To allow toggling the display ON/OFF using the “0” (zero) button
1st) Press the CODE button momentarily until the red LED is continuously lit.
2nd) Enter the code 242. The words “DISPLAY OFF” will be shown on the bottom line of the display.
3rd) The zero button can now be used to toggle the display on or off. Reverse this procedure to deacti -
vate this display on/off function
Enable or disable the External (remote) Trigger :
1st) Place the BCD-1 in standby mode by pressing the POWER button on either the BCD-1 itself or on the
remote control until the red standby LED on the front panel of the BCD-1 (immediately above the
front panel POWER button) lights.
2nd) Press the CODE button momentarily until the red LED is continuously lit.
3rd) Enter the code 241. Every time the code is successfully entered the state of the External Trigger will
toggle between enabled and disabled and the status of the External Trigger will be displayed on the
alpha-numeric display for 2 to 3 seconds.
The External Trigger utilizes a control voltage (3 to 12 volts, either AC or DC) connected to the
TRIGGER IN port on the rear of the BCD-1. A wire-clamp connector that mates with the TRIGGER IN
port is provided with every BCD-1 (See page 2 for wiring details). Once enabled the BCD-1 will only
be powered on when a control voltage of 3-12V AC/DC at ≥3mA is present. As soon as the control
voltage is withdrawn the BCD-1 will power down and go into standby mode.
Setting Output Attenuation (Gain) :
The gain of the BCD-1 can be adjusted from it’s default condition of 0dB (code 250) to -1dB (code 251), -2dB (code 252) or -3dB
(code 253)
1st) Press the CODE button momentarily until the red LED is continuously lit.
2nd) Enter the the desired attenuation code: 250 for 0dB, 251 for -1dB, 252 for -2dB or 253 for -3dB
Programming the remote control
:
The infra-red remote control supplied with the BCD-1 can also be used to control the volume and mute functions several other
Bryston products including the BP26 & BP6 preamps, B60R and B100 integrated amplifiers and the SP2 Surround Sound Proces -
sor/Preamp. To program the BR2 remote control to operate other Bryston models follow these steps:
1st) Press and hold the CODE button on the BR2 remote until the red LED begins to flash (usually takes about 5 seconds).
2nd) Enter a three digit code as follows:
711 : SP2 PreAmp/Processor
BCD-1 CD PLAYER