SYSTXBBRCT01
EVOLUTION
r
SYSTEM
CAT--5 (WIRED) BROADBAND
REMOTE ACCESS MODULE
Installation Instructions
NOTE
: Read the entire instruction manual before starting the
installation.
pointSET
t
U.S. Pat No. 7,415,102
TABLE OF CONTENTS
PAGE
SAFETY CONSIDERATIONS
1
. . . . . . . . . . . . . . . . . . . . . . . . .
INSTALLATION CONSIDERATIONS
1
. . . . . . . . . . . . . . . . . . .
INTRODUCTION
1
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Computer Requirements
1
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
CAT--5 B--SAM INSTALLATION
2
. . . . . . . . . . . . . . . . . . . . . . .
BEFORE STARTING:
2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Check Equipment and Job Site
2
. . . . . . . . . . . . . . . . . . . . . . . .
Component Location and Wiring Considerations
2
. . . . . . . . . .
Install Components
2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Connect Evolution Systems
2
. . . . . . . . . . . . . . . . . . . . . . . . . . .
Connect Auxiliary Sensor (optional)
2
. . . . . . . . . . . . . . . . . . . .
Connect Power Source and Network Cable
2
. . . . . . . . . . . . . . .
System Start--Up
2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Network Setup
3
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
MAC Address and Serial Number
3
. . . . . . . . . . . . . . . . . . . . . .
Self--Test
3
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
RS--232 Connector
3
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Updating System Profile
3
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Local PC Access
3
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Account Setup
3
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
TROUBLESHOOTING
3
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
SAFETY CONSIDERATIONS
Improper installation, adjustment, alteration, service, maintenance,
or use can cause explosion, fire, electrical shock, or other
conditions which may cause death, personal injury or property
damage. Consult a qualified installer, service agency or your
distributor or branch for information or assistance. The qualified
installer or agency must use factory--authorized kits or accessories
when modifying this product. Refer to the individual instructions
packaged with the kits or accessories when installing.
Follow all safety codes. Wear safety glasses, protective clothing,
and work gloves. Have a fire extinguisher available. Read these
instructions thoroughly and follow all warnings and cautions
included in literature and attached to the unit. Consult local
building codes and the current edition of the National Electrical
Code (NEC) NFPA 70.
In Canada, refer to the current editions of the Canadian Electrical
Code CSA C22.1.
Recognize safety information. When you see this symbol
on
the unit and in instructions or manuals, be alert to the potential for
personal injury. Understand the signal words
DANGER
,
WARNING
, and
CAUTION
. These words are used with the
safety--alert symbol.
DANGER
identifies the most serious hazards,
which
will
result in severe personal injury or death.
WARNING
signifies hazards, which
could
result in personal injury or death.
CAUTION
is used to identify unsafe practices, which
may
result
in minor personal injury or product and property damage.
NOTE
is used to highlight suggestions which
will
result in enhanced
installation, reliability, or operation.
INSTALLATION CONSIDERATIONS
The CAT--5 Broadband Remote Access Module (CAT--5 B--SAM),
part number SYSTXBBRCT01, is powered with a 24VAC
transformer. A 120VAC supply must be near the mounting
location. Provisions must be made to secure the transformer to the
outlet.
The D--wire (24VAC) from the Evolution
t
System must
NOT be used to power the Remote Access Module.
This instruction covers the physical installation and start up of the
CAT--5 B--SAM. Use this instruction to guide the actual
installation process after the Evolution System(s) have been
installed. One CAT--5 B--SAM is capable of handling two
Evolution Systems.
INTRODUCTION
The CAT--5 B--SAM connects to a network router and allows
remote connectivity for up to two Evolution Systems within the
same building. The Evolution System owner as well as authorized
dealer can monitor and control the system via the Internet as well
as by telephone. The CAT--5 B--SAM communicates through the
homeowner’s cable or DSL Internet service. Broadband Internet
service with a network router is required. The CAT--5 B--SAM is
not compatible with dial--up Internet service. The CAT--5 B--SAM
can also monitor a dry--contact sensor to provide a warning for the
presence of water in the building, or some other use. If the sensor is
active, the Evolution System will not be disabled or shut down.
Computer Requirements
The CAT--5 B--SAM uses a web--based application to control and
monitor the Evolution System. This application will work with any
graphic user interface PC operating system (Microsoft, Apple,
Linux). The web--based application is optimized for use with
Microsoft’s Internet Explorer version 6 and above. Other web
browsers are compatible with some possible screen formatting
issues.
