OL-B500-16
›
After the assembly of all motors the following situation should be obtained at the electrical connection in the door pole on
the wall. (1)
›
If there are no side screens, bring the screen cable and/or LED cable through the arm upwards and connect it there. (2)
›
For this, drill a hole in the aluminium plate on the pole and seal with silicone. (2)
›
The connection is explained later.
Cable screen motor (no. 2 in fugure 9a)
WITH SIDESCREEN
1
2
WITHOUT SIDESCREEN
1
9.b MOTOR CABLE
1
2
3
2
2
› Lay the motor cables as shown in the drawings below.
› Steps 2 and 3 only apply for the furthest screens.
› If applicable, conceal these cables under the PVC fabric support as well.
› In some cases it will be necessary to conceal the cable behind the screen during mounting of the screens.
Cable screen motor (no. 1 in fugure 9a)
Cable screen motor (no. 3 in fugure 9a)
