Brush Wolf 42X HD, Инструкция по эксплуатации и техническому обслуживанию

Страница: 6 / 20

— 6 —
Operation Instructions
1. Prior to operation check the blades and replace if cracked or damaged. All blades must be
replaced at the same time. Tighten the blade carrier to the blade bolts/nuts, and hydraulic
motor mount nuts. Check the hydraulic fluid. A low level could indicate a leak and require a
closer inspection of your unit.
2. Ensure pins or quick couplers are properly connected from the Brush Wolf to your excava-
tor/backhoe.
3. Verify the auxiliary hydraulic flow available at the stick of your excavator/backhoe is within
the range of the Brush Wolf rating of GPM - Gallons Per Minute.
4. Inspect the hydraulic couplers and wipe off water, dust or any debris. Dirt and debris can
damage hydraulic components. Once cleaned, connect the couplers from the cutter to the
auxiliary hydraulic system on the excavator/backhoe.
5. Connect the auxiliary hydraulic lines for the brush cutter to the excavator/backhoe. Twist
the collars of the quick connect couplers to secure the hydraulic connections.
6. Confirm all safety measures have been completed per the Safety Instructions. Most impor-
tantly make sure the area is clear of personnel and pets.
7. Enter shatter-proof cab door, engage seat belt, release brake and start engine. The runners
of the Brush Wolf should be as close to the ground as possible.
8. Slowly apply hydraulics to the Brush Wolf and increase the engine speed to high idle. Make
sure the unit is operating smoothly before moving the excavator/backhoe forward. When
temperatures are below zero allow additional time for hydraulic fluids to warm-up.
9. Maintain a speed to handle the volume of brush and to prevent stalling.
10. Stay alert for drop-offs, rocks, holes, abandoned wells and septic tanks. Do not operate or
drive across a steep embankment as this may cause a rollover and possible injuries or death.
11. To cut large diameter brush and trees, move forward slowly to make the cut.
12. When finished cutting, make sure the cutter is placed flat on the ground, throttle down the
excavator/backhoe and shut off the hydraulic flow to the unit, stop engine prior to leaving
the cab.
13. To disconnect hoses use proper hand protection as the couplers may be hot.