6
in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
ERROR CODES/TROUBLESHOOTING
XII. Fault Mode
• Fault mode occurs when there is a non-recoverable hardware error in the power
pack.
• To reset, unplug the charger and re-plug in again.
• If the unit doesn’t work it is recommended to discontinue use of the Solo and seek
technical support when a fault condition is encountered.
XIII. Thermal Shutdown
• If the power source inside the Solo reaches 140° F (60° C) or greater, the system will
shutdown.
• During thermal shutdown, the battery will be electronically disconnected from the
output jacks.
• During thermal shutdown, the unit cannot be charged.
• Allow the unit to cool before attempting to operate it again.
• Operation of the unit in environments with excessive temperatures may not be pos-
sible.
XIV. LED Indicator Quick Reference
• Red LED – Unit is Charging
• Green LED – Corresponds to the Battery Fuel LEVEL over its respective number of
bars
XV. Troubleshooting
Problem: No power to connected device.
1. Check to make sure there is a proper connection between the power cord and the
outlet.
2. Check to make sure the power cord is of the proper type to utilize the outlet it is
