Brunswick StringPin, Руководство по обслуживанию

Страница: 9 / 126

Section 1: Safety!
1-3
SAFETY REQUIREMENTS FOR STRINGPIN PINSETTERS
As with all machinery, a certain amount of risk is involved in working on the StringPin Pinsetter.
However, if the necessary care, knowledge and responsibility are exercised, damage to the pinsetter and
people involved in accidents can be avoided. The following steps should be taken:
Safety Guidelines
1. ONLY PROPERLY TRAINED PEOPLE ARE QUALIFIED TO WORK ON OR OPERATE
THE PINSETTER.
2. Never operate the pinsetter without ALL factory supplied guarding in place.
3. Never operate the pinsetter if a guard or safety device is damaged or improperly fitted to the
machine.
4. Never bypass, disable, or tamper with the safety switches or pinsetter function switches.
5. Never attempt to climb over or around any mechanical barrier or machine guard.
6. Reinstall all the machine guards and the ladder after any troubleshooting or maintenance work
has been done on the pinsetter(s) or ball accelerator.
7. Always face toward the machine when using the ladder to climb onto or off the machine. Only
one person should be on the ladder at any time.
8. Suitable clothing must be worn (for example: rubber-soled shoes). Do not wear loose clothing
such as neckties or smocks that could get caught in moving parts. Remove rings, watches,
earrings, bracelets and other jewelry to avoid injury.
9. Care should be taken while near the front of the machine. Accidentally blocking the photocell
beam may cause the pinsetter to cycle.
10. Always turn the pinsetter off before working on the machine. Use the Stop/Run Switches
mounted on the rear or front of the pinsetter to turn off the pinsetter.
11. If more than one person is working on a machine or if a stop/run switch will be out of reach
while working on the machine, turn off both stop/run switches to prevent a person from turning
on the pinsetter before the other person says he/she is clear of the pinsetter.
12. When working on both machines of a lane pair or components that are common to both
machines (for example: the ball accelerator) power must be turned off at the StringPin Pinsetter
Controller. In addition, the main power switch on the StringPin Controller must be locked into
the off position using a suitable locking mechanism.
13. Fire extinguishers must be on hand and maintained properly. Keep oily rags and other
combustibles in approved fire proof containers.
14. If more than one person is working on a machine, be sure the other person is CLEAR before
restarting the machine.