BRUNSWICK INSTALLATION MANUAL
PAGE 7
BLACK WOLF
ATTACHING BED CLOTH TO
FRAMED SLATE
Before attaching the billiard cloth, clean slate thoroughly.
FIGURE ONE
Step #1:
Lay the bed cloth over the top of the slate, nap
side up, with the nap running from the head end to the
foot end of the table.
NOTE:
In determining the direction of the nap, run
your hand lightly over the surface of the cloth. If it
meets resistance, it is going against the nap.
Step #2:
Leave only enough cloth overhang at the head
end and left side to permit tacking into the wood slate
frame. Leave the balance of cloth overhang at the foot
end and right side.
NOTE:
Do not spread tacks on the bed cloth. Keep them
in a container that slides over the cloth.
Step #3:
Tack or staple the cloth securely to the wood
frame at #1 with two tacks or staples approximately 2"
apart.
Step #4:
Stretch the cloth across the table and tack or
staple securely at #2 with two tacks or staples 2" apart.
FIGURE ONE
FIGURE TWO
Step #5:
Stretch the cloth from #1 to #3 and tack or
staple securely into the wood frame at the left side of the
table. See Figure B.
Step #6:
Stretching the cloth across the table from #3
and pulling from #2, tack or staple the cloth at #4.
FIGURE TWO
FIGURE THREE
Step #7:
On the left side, stretch the cloth tightly from
#1 toward the side pocket opening and tack or staple
securely at #5.
Step #8:
Repeat Step 5, stretching the cloth from #3 and
tacking or stapling at #6.
Step #9:
On the right side of the table, grasp the cloth
firmly and stretch across the table from #5 and toward
the side pocket from #2 and tack or staple at #7.
Step #10:
Repeat Step 7, stretching from #6 and toward
the side pocket from #4 and tack or staple at #8.
FIGURE THREE
LEFT SIDE
RIGHT SIDE
FOOT
HEAD
#3
#4
#2
#1
LEFT SIDE
FOOT
RIGHT SIDE
HEAD END
#3
#4
#1
#2
HEAD END
LEFT SIDE
FOOT
RIGHT SIDE
#5
#6
#7
#8
