Bruker BMPC/2, Техническое руководство

Страница: 21 / 136

21 Z31823_00_05
5 Software
The BMPC/2 control & monitoring software is the user interface for the entire BMPC/2.
The software is necessary for adjustment of all the important BMPC/2 and magnet sys-
tem parameters, as well as for the monitoring of all functions during normal operation.
5.1 Starting the BMPC/2 Software
To start the BMPC/2 Control software you will need to enter your account ID and pass-
word and press „Enter“. The account ID and password can be delegated from the
Administrator or Bruker Service. There are several different account levels available:
User - Standard User Level
This is the default user display mode. In this mode you can switch between the various
display modes with the following restrictions:
•
To change to the „Off mode“ it is necessary to reenter the user password.
• The functions under the
Tools
menu option are not available at this login level.
• The program can not be closed in user level.
Administrator - Revisionary Level
This mode is necessary for making changes in the BMPC/2 setup. Most of the functions
under the menu option
Tools
are available at this level, with a few exceptions that are
reserved for the Service level. The program can be closed while in administrator level.
Service - Service Level
This level is only accessible by Bruker service personnel and is only required during
installation.For more information on accounts and passwords refer to the section "Pass-
word & Codes" on page 97 .