BRUEL & KJAER PULSE 3560-B, Техническая документация инструкция

Страница: 26 / 162

PULSE Multi-analyzer System Type 3560-B/C/D/E – Installation and IDAe Hardware 18
Set the PC IP Address
If you wish to update the default IP address of the PC, or your PC has not been pre-installed
with an IP address by Brüel & Kjær, click the
Set IP button on the PULSE Front-end Setup
page. The PC Network Configuration utility (Fig.2.7) will start.
Fig.2.7
Setting the PC IP Address
The default network setup is a direct connection (point-to-point configuration) with the PC’s
IP address set at 10.10.10.50. All point-to-point setups must use this IP address.
If, however, you plan to connect your system to the in-house network, you have to obtain IP
addresses for the PC and the front-end from your network administrator (he will also know
if you need to use DHCP).
Note: To ensure a correct connection, review the “Network Considerations” on page 6
with your network administrator.
To use the IP address given to you by your network administrator, check the Change PC IP
Address box, then do one of the following:
• Choose the Use DHCP radio button to set the PC IP address using the network DHCP
server. The Set IP address box will then be disabled
• Choose the Set IP address radio button to manually configure the allocated IP address
given to you by your network administrator
Click Next . You will then be prompted to reboot your PC.