Getting Started
When you buy the SEA-DOO
®
SEASCOOTER
™
VS
Supercharged the battery is disconnected and needs to be
charged. Follow the safety cautions on pages 9 to 12 and
charging instructions on pages 13 to 16.
Using the SEASCOOTER
™
for swimming and snorkeling.
When swimming or snorkelling the SEA-DOO
®
SEASCOOTER
™
VS Supercharged should be kept positively
buoyant - this is done by simply making sure the Buoyancy
Chamber is empty and fitted inside the Nose Cone.
To use the SEASCOOTER
™
for swimming or snorkeling
follow these instructions.
1. Charge the battery and install just before use.
2. Make sure that Vent Plug is closed.
3. Place the SEA-DOO
®
SEASCOOTER
™
GTI into the water
so the Handle, Outer Nose Cone and Nozzle fill with water.
4. When ready to set off, switch the Master Switch to the On
position shown in figure 2.
5. Pull and hold both Triggers to start the Propeller.
(There is a short delay before the Propeller begins to
rotate).
6. To stop the Propeller, simply release the Trigger.
7. Always turn the Master Switch off when out of the water.
8.
Proper posture when using the SEA-DOO
®
SEASCOOTER
™
VS Supercharged
is important to
achieve the maximum speed - see figure 3 for the correct
position of the SEA-DOO
®
SEASCOOTER
™
VS
Supercharged when using it.
Use of Variable Speed
Your Seascooter features two speeds - for normal speed,
pull the right trigger only. For the higher speed, pull both
triggers together.
Fig.2
Shown in "ON" position
Rotate to turn "OFF"
Fig.3
CAUTION
Do not dive deeper than you would normally when
snorkeling, to ensure you can get back to the surface safely.
6
5
