BRP ROTAX 914 Series, Руководство оператора

Страница: 42 / 96

ATTENTION
At an engine start with low oil temperature, continue to observe
the oil pressure as it could drop again due to the increased flow
resistance in the suction line. Engine rpm may only be in-
creased so far as the oil pressure re-mains steady.
Step Designation Procedure
10 Starting carb
(choke) De-activate and adjust engine
rpm as necessary.
To observe
Reduction gear with shock absorber
ATTENTION
Since the engine comprises a reduction gear with shock ab-
sorber, take special care of the following:
Step Procedure
1 To prevent impact load, start with throttle lever in idle po-
sition or at the most up to 10% open.
2 For the same reason, wait for around 3 sec. after throt-
tling back to partial load to reach constant speed before
re-acceleration.
3 While checking the two ignition circuits, only one circuit
may be switched off at a time.
3.5) After engine start
m WARNING
Non-compliance can result in serious injuries or death!
Do not start the engine if any person is near the engine.
Warming up
period
Step Procedure
1 Start warming up period at approx. 2000 rpm for approx.
2 minutes.
2 Continue at 2500 rpm, duration depending on ambient
temperature, until oil temperature reaches 50 °C (120 °
F).
3 Check temperatures and pressure.
Page 3-8
August 01 2019 BRP-Rotax Effectivity: 914 Series
Rev. 0