BRP ROTAX 914 Series, Руководство оператора

Страница: 38 / 96

Mech./electronic
components
Check of mechanical/electronic components.
Step Procedure
1
NOTE
Propeller shouldn't be turned in reverse of the nor-
mal direction of engine rotation.
Turn propeller slowly by hand in direction of engine rota-
tion several times and observe engine for odd noises or
excessive resistance and normal compression.
2 Verify free movement of throttle valves over the complete
range.
3 Inspect for damages, leakage and general condition of ex-
haust system and turbocharger.
4 Visual inspection for mechanical and thermal damages of
sensor, actuators and the wiring harness.
ATTENTION
At excessive resistance of the engine perform the relevant un-
scheduled maintenance check according to Maintenance Man-
ual (Line), chapter “Hard to turn over“.
Gearbox
Version without overload clutch:
No further checks are necessary.
Version with overload clutch:
Step Procedure
1 Turn the propeller by hand to and from, feeling the free
rotation of 30° before the crankshaft starts to rotate.
If propeller can be turned between the dogs frictionless
(lower than 25 Nm (19 ft.lb)), further inspection is
required.
Carburetor
Step Procedure
1 Verify free movement of throttle cable and starting car-
buretor over the complete range. Check from the
cockpit.
Page 3-4
August 01 2019 BRP-Rotax Effectivity: 914 Series
Rev. 0