BRP E200DHLSEB, Руководство по обслуживанию

Страница: 116 / 412

114
SYSTEM ANALYSIS
DIAGNOSTIC PROCEDURES
Troubleshooting
Outboard will not crank, starter does not
operate:
•
Check condition of battery and cables (main
battery switch and cables). Make sure battery
cables are not reversed.
•
Confirm that switched B+ is present at “A” termi-
nal (purple wire) of starter solenoid with key
switch in the ON position.
•
Refer to
ELECTRIC START TESTS
on p. 140.
Repair starter or start circuit as needed.
Outboard cranks, will not start:
•
Check emergency stop switch and lanyard
•
Check the
EMM
LED Indicators for system sta-
tus information. Refer to
EMM LED INDICA-
TORS
on p. 116.
•
Use the
Evinrude Diagnostics
software
Stored
Faults
screen to check for current service
codes. If there are multiple stored sensor
codes, inspect all 5 V sensor circuits for broken
or grounded wiring.
•
Perform a Static Ignition test using
Evinrude
Diagnostics
software and an inductive timing
light. Refer to
Static Ignition Test
on p. 120.
•
If ignition test indicates steady spark, refer to
FUEL DELIVERY TESTS
on p. 123.
Outboard runs, low on power, misfires:
•
Check the
EMM
LED Indicators for system sta-
tus information. Refer to
EMM LED INDICA-
TORS
on p. 116.
•
Use the
Evinrude Diagnostics
software
Monitor
screen to check system (55 V) and TPS volt-
ages. System voltage should be steady, and
TPS voltage should be between 0.2 and 4.85 V.
IMPORTANT:
Use a digital multimeter to check
voltage on external circuits only when necessary.
All
EMM
output currents are DC current.
•
Use the diagnostics software
Dynamic Tests
to
isolate a faulty cylinder. See
DYNAMIC TESTS
on p. 115.
•
Use an inductive timing light to check ignition
and fuel injector circuits. Refer to
Running Igni-
tion Tests
on p. 121 and
Running Fuel Sys-
tem Tests
on p. 124.
•
Use the diagnostics software
Fuel Control
Adjustment
test to help identify a cylinder that
may be too rich or too lean. Refer to
Fuel Con-
trol Adjustment
on p. 115.
•
Use an inductive amp meter to monitor injector
circuit current. Compare readings of all circuits
to identify possible failure.
•
Check fuel quality and that fuel is present at
injectors.
•
Use the diagnostics software
Logging
function
to record engine data as a problem is occurring.
•
AFTER all the above inspections, if the cause of
a running quality problem still cannot be identi-
fied, perform a compression test to check for
internal powerhead damage.
IMPORTANT:
Remove a cylinder head or disas-
semble the engine only as a last resort.
Logging Screen
006549