BRP E 250 L HO AG B, Руководство по обслуживанию

Страница: 39 / 460

39
Routine Service
Operational Checks
2
Operational Checks
Start-In-Gear Prevention
Start outboard and shift to FORWARD.
Turn outboard OFF while control is in FORWARD.
Try to restart the outboard. Outboard should not
start.
Shift back to NEUTRAL and restart outboard.
Shift to REVERSE. Turn outboard OFF while con-
trol is in REVERSE.
Try to restart the outboard. Outboard should not
start.
Remote Control Operation
Make sure that control can be easily moved into
all gear and throttle settings.
Emergency Stop / Key Switch
Check emergency stop function. With outboard
running at IDLE, pull safety lanyard from emer-
gency stop switch. Outboard must stop immedi-
ately. If equipped, be sure to check emergency
stop function of second station.
Digital Displays and Gauges
Complete basic set up of digital display or gauges.
Configure engine and fuel tank, set fuel tank
capacity etc. Refer to User’s Guide.
Tachometer Pulse Setting ( SystemCheck )
Confirm accuracy of tachometer reading.
•
Adjust dial on back of tachometer to required
setting (the outboard should not be running).
Engine Monitoring System
Attach emergency stop lanyard.
Turn key switch to the ON position.
Evinrude Touch-Screen Display — The touch
screen system will run a start up sequence and
then display the
Evinrude welcome page. When
the start up sequence is complete, the default dig-
ital display will appear.
ICON — The ICON system self-tests by sounding
a beep. The ICON tachometer and speedometer
LCD screens display SELF TEST MODE IN
OPERATION. When the self test is complete, the
gauges will beep a final time and then display
SELF TEST COMPLETE!
I-Command — The I-Command system self-tests
by displaying the Evinrude E-TEC welcome
screen, followed by the default digital display.

DANGER
DO NOT run the engine indoors or without
adequate ventilation or permit exhaust fumes
to accumulate in confined areas. Engine
exhaust contains carbon monoxide which, if
inhaled, can cause serious brain damage or
death.

WARNING
Contact with a rotating propeller is likely to
result in serious injury or death. Assure the
engine and prop area is clear of people and
objects before starting engine or operating
boat. Do not allow anyone near a propeller,
even when the engine is off. Blades can be
sharp and the propeller can continue to turn
even after the engine is off.

CAUTION
DO NOT run outboard without a water supply
to the outboard’s cooling system. Cooling
system and/or powerhead damage could
occur.

WARNING
Make certain that the starter will not operate
when the outboard is in gear. The start-in-
gear prevention feature is required by the
United States Coast Guard to help prevent
personal injuries.
Outboard Model Tachometer Setting
15–300 HP 6 Pulse or 12 Pole