BRP E 250 L HO AG B, Руководство по обслуживанию

Страница: 22 / 460

22
Routine Service
Maintenance
IMPORTANT:
The recommended gear lubricant
is formulated for marine applications. Do not use
automotive gear lubricants, engine oils, or any oth-
er oil or grease.
Secure the gearcase in a vertical position.
Use Gearcase Filler, P/N 501882, to slowly fill the
gearcase with
HPF PRO lubricant until lubricant
level in the reservoir is between the marks as
shown in
Lubricant Level on p. 20.
IMPORTANT:
Filling the gearcase too quickly
can cause air pockets and the gearcase may not fill
completely.
Clean plug seal area and install the lubricant
drain/fill plug and a
new seal. Tighten the plug to a
torque of 60 to 84 in. lbs. (7 to 9.5 N·m).
Install the water screens. Tighten the screw to a
torque of 10 to 14 in. lbs. (1.2 to 1.6 N·m).
Install the vent hose on the reservoir upper fitting.
Install the starboard side panel.
Spark Plugs
Spark plugs should be removed and examined
periodically. Replace worn, fouled or damaged
spark plugs.
Use only recommended spark plugs with the cor-
rect gap setting.
Removal
Remove the engine cover panels. Remove spark
plugs and inspect condition.
Starboard Spark Plugs
Remove the spark plug leads from the spark
plugs.
Use a spark plug socket, extension and wrench to
remove the spark plugs.
Port Spark Plugs
Remove the spark plug leads from the ignition
coils.
Use an 8 mm socket to remove the screw and
washer from the ignition coil mounting brackets.
Move the ignition coil and bracket assemblies to
the side as shown.
Remove the spark plug leads from the spark
plugs.
Use the spark plug socket and a combination
wrench to remove the spark plugs.
1. Lubricant drain/fill plug 009165
1. Vent hose upper fitting 009141
1
1
Spark Plug, Champion
Q C 8 W E P I @ 0.028 ± 0.003 in. (0.76 mm)
009244