BRP E 250 L HO AG B, Руководство по обслуживанию

Страница: 20 / 460

20
Routine Service
Maintenance
Flushing — Outboard Running
Place outboard in VERTICAL (DOWN) position in
a well ventilated area.
Thread garden hose into flushing port.
Turn water supply on.
Run outboard at IDLE only until full operating tem-
perature is reached.
Leave the outboard in VERTICAL (DOWN) posi-
tion long enough for the powerhead to drain com-
pletely.
Reinstall propeller.
Flushing — Outboard Not Running
Place outboard in VERTICAL (DOWN) position.
Thread garden hose into flushing port.
Turn water supply ON.
Flush outboard for at least five minutes.
Turn off water supply and remove garden hose.
Leave the outboard in VERTICAL (DOWN) posi-
tion long enough for the powerhead to drain com-
pletely.
Propeller Shaft
Debris from the water can become lodged around
propeller shaft. Frequent inspection can minimize
potential gearcase damage.
Remove propeller. Refer to Propeller Hardware
Installation on p. 360.
Inspect bushing and blade surfaces. Replace
damaged or worn propellers.
Clean propeller shaft. Inspect propeller shaft
seals. Replace damaged or worn seals.
Apply Triple-Guard grease to entire length of pro-
peller shaft prior to installing propeller.
Reinstall propeller hardware and propeller.
Gearcase Lubricant
Refer to the Inspection and Maintenance
Schedule on p. 16 for service frequency.
Lubricant Level
Remove the starboard side panel.
IMPORTANT:
ALWAYS check the fill level of the
gearcase lubricant at the oil reservoir before re-
moving the drain/fill plug.

WARNING
To prevent injury from contact with rotating
propeller, remove the propeller before flush-
ing.
009071

WARNING
When servicing the propeller, always shift the
outboard to NEUTRAL position, turn the key
switch OFF and remove the key, so the out-
board cannot be started accidentally.
1. Lubricant reservoir 009140
1