(6) With the filler on a flat hard surface, place the clip end of the trigger
over the groove in the beer tube, oriented as shown in Fig. 8. Pressing
on BOTH sides of the tube (to prevent bending) push it into the groove
until it clicks into place. To remove it, invert the filler and again push
down on both sides of the tube until it snaps out of the trigger clip
.
(7) Slip the 10ft length of 3/16 ID beer hose onto the end of the beer
tube about 3/8” as shown in Fig. 9. Installing it deeper than this makes
removal more difficult. Using a shorter length of hose, or a hose with a
larger ID, will increase the likelihood of foaming. Connect the other end
of the hose to the beer out on the keg using a liquid ball lock connector
(included in the accessory kit).
(8) Connect the CO
2
hose to the brass valve as shown in Fig. 10. The
fittings shown are included with the optional accessory kit.
(9) Connect the beer hose and CO
2
hose to your regulator as shown in
Fig. 11.
That’s it! After a few uses, it will take less than a minute to assemble the filler.
Brouwland
Korspelsesteenweg 86 • B-3581 Beverlo - Belgium
Tel. +32-(0)11-40.14.08 • Fax. +32-(0)11-34.73.59
[email protected] • www.brouwland.com
Fig. 10
Fig. 9
Fig. 8
4 / 8
Manual
058.121.4 Bottle-filler Beergun with accessory kit
058.122.3 Bottle-filler Beergun
