5
g
With the backing facing down, attach the laminated
sticker to a standard tack adhesive mat.
h
Select a test pattern (refer to the Operation Manual for
the cutting machine), arrange the cutting pattern to avoid
the printed image, and then cut out the test pattern.
• Set Half Cut to ON on the settings screen. The settings are
appropriately specified when pressing around the cuts causes
the cut sections to curl so that the yellow backing is visible.
This feature is only available auto-blade holder is installed.
Note
• Before cutting the sticker pattern, be sure to perform trial
cutting.
i
Peel off the laminated sticker and check that its backing is
not cut.
• If the backing of the sticker sheet is cut, adjust the Cut Pressure
(Half Cut) to lower it so that the backing is not cut.
j
Use the “Direct Cut” mode to cut the outline of the image
(refer to the Operation Manual for the cutting machine).
k
Peel the cutout sticker from the sticker sheet.
• The laminated sticker can be easily peeled off if the lifter is
inserted between the sticker and the backing.
l
Affix the sticker at the desired location.
Note
•
Depending on the environment, the sticker may peel off. In
addition, if the sticker is affixed to a surface that is rough,
uneven, wet, or oily (including wax or silicone), the sticker
may peel off. For best results, make sure surfaces are dry
and oil-free before affixing sticker.