Brother P-touch PT-2310, Руководство по обслуживанию

Страница: 55 / 113

38 II-
[ 12 ] Demonstration Print and Final Check
Following items are verified lastly after completed the assembly.
1. Press the “On/Off (
) ” key.
2. While holding down the “Code” key, press the “BS (
) ” key to cancel data previously
entered.
3. While holding down the “Code” key , press the “D” key to start the demonstration print.
4. During the demonstration print, check that the machine feeds the tape and the prints data
correctry. Then cut the tape. If any problem is found, go to the trouble shooting in chapter
4.
5. Open the casssette cover ASSY to check that it retracts the roller holder ASSY from the
termal head. Thereafter, the cutter safety lock mechanism is verified no problem after
removed the laminate cassette tape.
6. Remove the batteries, and set the AC adapter. After that, comfirm the “On/Off ( )” key.
7. At last, no problem is verified by conducting the following inspections.
7.1. Inspection Mode Starting Procedure
The inspection mode is initiated by pressing the “CODE” key, “K” key, and “On/Off ( )”
key simultaneously when internal RAM is cleared while electrical power OFF. (Displays will
become as shown in Fig. 2.) * First, release the “On/Off (
)” key.
However, Error processing will be started when occurred the following error. When such is
the case, please repair by referencing to the Chapter 4 trouble shooting.
7.1.1. Soldering Checks
Checks are performed for the solder points.
Operation is finished by displaying as shown in Fig. 1 when the solder is ON for more than 2
points, or when the soldering made to inappropriate position.
Fig. 1
7.2. Modes for Inspection “1” ~ “7” Key
This mode is a mode to perform the final inspection after completed the assembly.
Fig. 2
Display shown in Fig. 1 appears
only when there is an error at the
solder point.