SEWING BASICS
———————————————————————————————————————————————————————————————————————————————————————————————————————
52
Pulling up the bobbin thread
When making gathers or before free-motion quilting,
first pull up the bobbin thread as described below.
a
Insert the bobbin into the bobbin case.
• Refer to steps
a
through
d
of “Installing
the bobbin” (page 18).
b
Pass the bobbin thread through the slot.
Do not cut the thread with the cutter.
c
While lightly holding the upper thread with
your left hand with the needle in the up-
position, press
(needle position button)
twice to lower and raise the needle.
a
Needle position button
X
The bobbin thread is looped around the
upper thread and can be pulled up.
d
Carefully pull the upper thread upward to pull
out the end of the bobbin thread.
e
Pull out about 10-15 cm (4-5 inches) of the
bobbin thread under the presser foot toward
the rear of the machine.
f
Reattach the bobbin cover.
Insert the tab in the lower-left corner of the
bobbin cover (A), and then lightly press down
on the right side (B).
1
A
A
B
Содержание NS-40
Страница 6: ...5 ...
Страница 89: ...UTILITY STITCHES 88 ...