Brother Innov-is 1500D, Руководство по эксплуатации

Страница: 54 / 201

SEWING THE STITCHES
Ut
ili
ty Stit
ch
es
53
3
■
Basting
a
Press , and then attach presser foot “J”.
b
Press the “Reverse/Reinforcement Stitch”
button to sew reinforcement stitches at the
beginning of the stitching.
c
Sew while lightly guiding the fabric.
d
End the basting with reinforcement stitches.
Darts Seams
a
Press , and then attach presser foot “J”.
b
Press the “Reverse/Reinforcement Stitch”
button to sew reverse stitches at the
beginning of the stitching, and then sew from
the wide end to the other end without
stretching the fabric.
* If the automatic reverse/reinforcement stitching
setting is selected before sewing, reverse stitches
will be sewn at the beginning of the stitching.
a Basting
c
Without sewing reverse stitches at the end of
the stitching, pull out 50 mm (approx. 1-15/
16 inches) of the threads, cut them, and then
tie the two ends together.
d
Insert the ends of the thread into the dart
with a sewing needle.
e
Iron the dart to one side.
Memo
For a standard 16 mm (approx. 5/8 inch) seam
allowance, set the width to 0 mm on the screen. While
sewing, align the edge of the fabric with the 16mm
(approx. 5/8 inch) mark on the needle plate.
a
16 mm (approx. 5/8 inch)
Memo
The stitch length can be set between 5 mm and 30 mm
(approx. 3/16 and 1-3/16 inches).
a
Between 5 mm (approx. 3/16 inch) and 30 mm
(approx. 1-3/16 inches)
Memo
This is easy to do if the foot controller is used
( see page 39).
J
a
a
a