IV
- 9
4.3.6
Operational check of keys and LEDs on the control panel [Function code 13]
n
n
Function
This function allows you to check the keys and LEDs on the control panel.
n
n
Operating Procedure
(1) Open the paper compartment cover and hold down the
COPY
and
FEED
keys for 15
seconds.
(2) Press the
COPY
key with the paper compartment cover opened.
The
ERROR
and
PAPER
LEDs start flashing at 0.5-second intervals alternately.
(3) Press the
COPY ALL
key.
The
PAPER
LED goes off but the
ERROR
LED keeps flashing.
(4) Press the
COPY
key.
The
ERROR
LED goes off and the
PAPER
LED starts flashing.
(5) Press the
FEED
key.
The
PAPER
LED goes off.
The machine returns to the regular operation mode.
4.3.7
Sensor operational check and EEPROM customization (for page length) [Function code 32]
n
n
Function
This function allows you to check whether the PE/cover sensor works correctly. After checking the
sensor, you select letter or A4 size for page length.
n
n
Operating Procedure
(1) Open the paper compartment cover and hold down the
COPY
and
FEED
keys for 15
seconds.
(2) Press the
FEED
key with the paper compartment cover opened.
The
PAPER
LED should come on.
(3) Load paper, then close or open the paper compartment cover to check that the
PAPER
LED
goes off or comes on, respectively.
Remove or set the recording paper to check that the
PAPER
LED comes on or goes off,
respectively.
(4) Press the
COPY
key.
The
ERROR
LED should come on if it was off.
The
ERROR
LED should go off if it was on.
Before proceeding to the following steps, fix the sensor problem (if any) and check that the
ERROR
LED goes off.
Содержание CB200
