Attach the rear band
1.
Press the area highlighted in the image below, and slide the head band
cover towards the end of the band to remove it.
2.
Slide the loop at one end of the rear
band over the attachment post as
shown in the illustration, and feed
the rear band through the opening
at the end of the head band.
3.
Replace the head band cover as
shown, ensuring that the rear
band is fed through the cut-out on
the end of the cover. Press the
area highlighted in the illustration
and slide the cover back into
place.
4.
Repeat Steps 1-3 to attach the other end of the rear band to the other
end of the head band.
5.
Adjust the rear band's length using the slider.
Switch the head display to be viewed with the
right eye
While the AiRScouter is supplied with the head display screen on the
left side of the head band, the flexible arm may be switched to allow
the head display to be positioned over the right eye instead.
1.
Ensure that the AiRScouter is powered off and that the head display
cable is disconnected from the control box before continuing.
2.
Remove the head display cable from the cable channel on the head
band, and from the cable channel on the flexible arm.
3.
Rotate the dial on the ball joint between the flexible arm and the head
band clockwise, until the flexible arm is separated from the head band.
4.
Rotate the dial on the ball joint between the flexible arm and the head
display clockwise, until the flexible arm is separated from the head
display.
5.
Turn the head band over so that the threads of the ball joint face the
other way, and the AiRScouter logos on the head band covers are
upside-down.
6.
Remove the two head band covers as shown, by pressing the area
highlighted in the image below and sliding the cover to the end of the
head band. Swap the two covers and replace them as shown, so that
the AiRScouter logos are now facing the correct direction.
7.
Attach the flexible arm for right-eyed viewing (the other arm that is
included in the box) to the head display, by lining up the narrow end
of the flexible arm with the threads on the head display and rotating
the dial on the ball joint clockwise to tighten.
Note
The flexible arm for left eye and the flexible arm for right eye are two
separate parts that are included in the AiRScouter box. Because of its
design, the flexible arm for right eye cannot be used for left-eyed
viewing, and vice versa.
