200707_3
9
Assembly – Positioning the Coal Ceramics
Only the ceramics supplied with this appliance should be used. The ceramics
should only be laid as described. Replacement ceramics are available from your
dealer. Whilst arranging the ceramics, ensure that the pilot is not obstructed.
Broseley Fires Ltd accepts no responsibility for any injury sustained whilst
handling hot ceramics.
Before any ceramics are placed in position ensure
that the burner is operating correctly.
The flames should be fairly even across
the burners mesh top.
Ceramics which are found to be placed other than in
accordance with these instructions will result in a charge being made
following any service callout.
COAL LAYOUT
Warning: Ceramic coals are very fragile so always handle with care when
fitting them. Follow these instructions carefully. Ceramics that are
positioned wrongly could seriously alter the performance of your
appliance.
Step 1
Open the door fully, you may wish to lift it from its hinges. Take the large base
ceramic coal matrix making sure the front edge is facing towards you. Pick up the
ceramic with both hands, placing the fingers gently through the flame holes.
Support the weight at all times as the ceramics are fragile and damage easily.
During the placement do not force the ceramic into position as it will break.
Turn the front edge of the ceramic to face downwards and insert the right hand
side first into the rear right corner of the stove. It should now be possible to gently
follow with the left hand and at the same time rotate the ceramic upwards so that
it lays flat on the burner. The ceramic should be against the back of the stove
and central about the burner mesh.
