© 2007-2008 Broseley Fires Ltd 9
method is to brush the surface with a soft brush. This is good for cleaning in the more detailed and difficult to get
to areas. If cast iron is left for long periods in a damp atmosphere; such as a fireplace; it may start to show signs
of rust. To prevent this, wipe the surface over with light oil. This will burn off when the fire is re-lit.
16 C
GLASS CLEANING:
Only clean the glass when the appliance is cold. There are various glass cleaners you can buy at stove shops
that are specially designed to remove hydrocarbon (soot) and fly ash (mineral) deposits from the glass. Follow the
manufacturer’s instructions. Typically, just spray a small amount of cleaner on the glass and use a paper towel or
rag to wipe it clean. Alternatively use a proprietary ceramic hob cleaner such as Hob-brite, as used for ceramic
hobs. Follow the directions on the product. The directions for use on the bottle are to turn the appliance off, apply
cleaner with paper towel or clean cloth, rub the glass lightly, rinse residue and dry the glass with a paper
towel/soft clean tissue.
If you only burn logs in your appliance, then you can dip a damp cloth in the ash and use this to scrub the glass
clean. Do NOT use this method if you use coal, as the ash produced is too abrasive.
16 D
BROKEN GLASS
The glass in the fire door is ceramic and is resistant to sudden temperature changes up to 750 degrees
Centigrade. Breakage can only be caused by mechanical shock (collision, violent damage etc) because of this,
replacement is not covered by the guarantee.
16 E
ASH REMOVAL:
The efficient operation of your appliance is dependant on its correct installation, operation and maintenance.
Leaving soot to accumulate inside your appliance will drastically reduce the output of the appliance and prevent it
from doing what it is designed to. Ensure that the ash inside every part of the appliance is removed, not just the
ash pan. Ash will settle on top of the baffle and this is an area that will also need periodic inspection.
16 F
FLUE MAINTENANCE:
Call a certified chimney sweep (National Association of Chimney Sweeps) or other qualified professional to clean
the flue system. These professionals have the equipment and the experience to do a thorough job. The sweep will
advise you as to the intervals that you should have your flue swept. We would recommend that you have it swept
at least twice a year, but you may need to sweep it more.
Get them to inspect the condition of all the associated chimney items and report to you on their condition.
Since coal residue contains sulfur, the metal flue pipe and chimney systems tend to deteriorate much faster than
when burning wood. Be sure to check the pipe at least once every six months to determine if it has corroded.
16 G
ROPE SEALS:
For the appliance to operate correctly, it is important that all the seals; where fitted; are in good condition and are
sealing correctly. They should be replaced if they are showing excessive signs of fraying and are not making a
good seal. They are glued into position using a high temperature, flexible, silicone sealant
16 H
SOAPSTONE
Allow the soapstone to cool to room temperature on its own before cleaning. Rinsing with a sponge and hot water
is usually sufficient to clean soapstone.
16 I
AIR CONTROLS:
Ensure that all the air controls operate smoothly and are free from ash or other foreign bodies. Pay particular
attention to the damper flap at the rear of the ash drawer. Clean this area with care and ensure that excessive
amounts of ash are kept from building up and affecting the operation of this control.
17 SPARES
THE APPARATUS MUST NOT BE MODIFIED IN ANY WAY.
ONLY SPARE PARTS EXPRESSLY AUTHORISED OR SOLD BY BROSELEY FIRES LTD. MAY BE USED.
CONSULT YOUR LOCAL AUTHORISED DEALER FOR ADVICE.
