Brookstone u Control, Инструкция по эксплуатации, Страница: 8 / 20

chaRGinG YouR helicoPTeR
1. Make sure the ON/OFF SWITCH on the
helicopter is set to the OFF position.
2. Slide the CHARGING PLUG COMPARTMENT
cover on the front of the remote control to the
open position to access the CHARGING PLUG.
3. Connect the CHARGING PLUG on the
controller to the CHARGING SOCKET
on the helicopter (see right).
4. Turn the remote’s ON/OFF SWITCH
to the ON position. The green and red
lights on the remote will illuminate,
indicating that charging is in process.
Note: the length of charging time will vary depending on percentage of battery
already charged and the strength and condition of the AA batteries in the
charger. Average charge time is 20-30 minutes.
5. The green charging indicator will shut off when the helicopter is fully charged.
6. Unplug the CHARGING PLUG from the CHARGING SOCKET and store in
the CHARGING PLUG COMPARTMENT so it doesn’t interfere with the controls.
ImPOrtANt: make sure to disconnect the CHArGING PluG from the
helicopter’s CHArGING SOCKet as soon as charging is complete.
Failure to do so will cause excessive drain on the remote’s batteries.
7
Charging Socket
ON OFF
CHG