Improving FM Reception
Fully unwind the FM WIRE ANTENNA located on the back of the
system and position it for best sound.
Replacing the Remote Control Battery
1. Slide the BATTERY COMPARTMENT open.
2. Remove the old battery and insert a new CR2025 battery into the
battery compartment, ensuring the positive (+) side faces up.
3. Close the BATTERY COMPARTMENT.
Note:
When the remote control is not going to be used for more than
30 days, remove the battery to prevent it from leaking. If it leaks, wipe
away the liquid inside the BATTERY COMPARTMENT and replace with a
new battery.
31
512574 M
icr
o S
y
st
em w/MP3 D
o
c.
Siz
e
:5
"W x 4.75"H
Output at 100% P
rints 1/0 Black
8. WALL OR CEILING MOUNTING
The unit should be mounted to a wall or ceiling only as
recommended by the manufacturer.
9. VENTILATION
The unit should be situated so that its location or position does
not interfere with its proper ventilation. For example, the unit
should not be situated on a bed, sofa, rug or similar surface that
may block the ventilation openings or placed in a built-in
installation, such as a bookcase or cabinet that may impede the
flow of air through the ventilation openings.
10. HEAT
The unit should be situated away from heat sources such as
radiators, heat registers, stoves, or other units (including
amplifiers) that produce heat.
11. POWER SOURCE
The unit should be connected to a power supply only of the type
described in the operating instructions or as marked on the unit.
12. GROUNDING OR POLARIZATION
Precautions should be taken so that the grounding or polarization
means of a unit is not defeated.
13. POWER CORD PROTECTION
Power-supply cord should be routed so that it is not likely to be
walked on or pinched by items placed upon or against it, paying
particular attention to cord at outlets, convenience receptacles,
and the point where it exits the unit.
6
512574_INS_MicroSysw/MP3 PG 9/13/05 2:43 PM Page 11
